A Water Surface Wave-Height Radio Telemeter

ABSTRACT

This paper discusses the evolution of a telemetric device that enables the remote measurement of surface wave height on a freshwater lake. The basic instrumentation package uses an anchored, insulated metal probe as a capacitive sensor element to determine peak wave amplitudes up to 1 m; the probe also serves as the mechanical support for a lightweight UHF radio-link antenna. The principal system design considerations and circuit details of the baseband signal processing stages are included; representative test results are documented.     

Design of optimum actively compensated networks

This paper describes an active compensation technique which is readily applicable to all active-RC networks, independently of the circuit topology. This procedure considers the network in its totality and derives general active compensation conditions for a generic active-RC network employing 2 or 3 operational amplifiers. Furthermore, the remaining degrees of freedom of the circuits are used to optimize the performance of the actively compensated circuits to further extend its operating frequency range. Simulation and experimental results are also reported.     

Exchange Interactions at the Interface FMIAFM Nanocomposite Obtained by Mechanochemical Synthesis

This paper presents a study of the relationship between the magnetic properties and microstructure of nanocomposite Ni/MnO, Ni/CoO, Co/MnO, Co/CoO. The objective is to understand how the coupling interface FM/AFM （ferromagnetic/anti-ferromagnetic） manifests itself in magnetic response of these materials to an applied field. Sample preparation was performed using mechanochemical synthesis by means of a ball mill planetary type high power at normal atmosphere. The characterization was done by XRD （X-ray diffraction）, SEM （scanning electron microscopy） and VSM （vibrating sample magnetometry）. Analyzing the XRD peaks of the samples studied, there was a decrease in the average particle diameter with increasing milling time, which is important in the magnetic interactions of the atoms of the surface. In addition, the diffraction pattern showed formation of new phases by oxidation interfering with the magnetic measurements. Analyses by SEM show chipboard multiform nano- and micrometer-sized grains on the surface of the clusters being responsible for the interaction. The magnetic measurements show a strong coupling between the phases present in nanocomposites showing once again that the MS （mechanosynthesis） is a powerful technique for this kind of purpose. The effect of the decrease in crystallite size leads to large variations of magnetic properties of the material which have been specifically observed changes in HC （coercive field） in the RM （remanent magnetization） and SM （saturation magnetization）. The decrease in crystallite size in the course of grinding intensifies the effects that depend on the surface-to-volume ratio of the material. M vs. T measures were taken for different values of applied field and found a jump in the moment of the sample near the N6el temperature of the antiferromagnetic.     

Authenticity Control of Roasted Coffee Brands Using Near-Infrared Spectroscopy

In this work, a methodology based on near-infrared spectroscopy (NIRS) was exploited in order to discriminate between commercial coffee brands. The main advantages of this approach compared to other strategies (e.g., wet chemistry methods) are its lower cost, less labor, and lower time per analysis. Two commercial brands were discriminated among several others present in the Portuguese market. The chemometric method used to estimate discriminant models was partial least squares discriminant analysis (PLSDA). Results show that it is possible to discriminate coffee brands using this strategy with a correct classification of 100 %. The spectral region, more favorable to discrimination of roasted coffee brands, can be related with differences in the concentrations of compounds, such as, chlorogenic acid and sucrose, and also due to differences on lipid fraction. This methodology is adequate for field implementation, namely, adopting handheld NIRS instruments.     

Hydrogen PEMFC stack performance analysis: A data-driven approach

For low power fuel cells, management of reactants, water and heat, must be realized in a passive fashion in order to minimize parasitic losses. Effective fuel, oxygen supply and water management for reliable performance are also greatly affected by cell geometry and materials. These are complex systems to optimize on a mere experimental basis. As an aid to this goal, data-driven analysis techniques, requiring no a priori mathematical model, are gaining a reputation in other research fields, where phenomenological modeling approaches might be intractable.     

Anticoagulant, Antioxidant and Antitumor Activities of Heterofucans from the Seaweed Dictyopteris delicatula

In the present study, six families of sulfated polysaccharides were obtained from seaweed Dictyopteris delicatula by proteolytic digestion, followed by acetone fractionation and molecular sieving on Sephadex G-100. Chemical analyses demonstrated that all polysaccharides contain heterofucans composed mainly of fucose, xylose, glucose, galactose, uronic acid, and sulfate. The fucans F0.5v and F0.7v at 1.0 mg/mL showed high ferric chelating activity (～45%), whereas fucans F1.3v (0.5 mg/mL) showed considerable reducing power, about 53.2% of the activity of vitamin C. The fucan F1.5v presented the most prominent anticoagulant activity. The best antiproliferative activity was found with fucans F1.3v and F0.7v. However, F1.3v activity was much higher than F0.7v inhibiting almost 100% of HeLa cell proliferation. These fucans have been selected for further studies on structural characterization as well as in vivo experiments, which are already in progress.     

Field validation of specific ecotoxicological tools for aquatic systems impacted with acid mine drainage

Acid mine drainage (AMD) is characterised by very low pH and high heavy metal concentrations. Serious ecotoxicological effects, often leading to the complete disruption of the ecosystem, can be observed at the regions suffering this kind of contamination. Those effects can be caused either by low pH itself or by other contaminants that emerge with water acidification (mobilisation and increased solubility of heavy metals). The discrimination between the toxicity due to each of these two factors is not possible with the existing toxicity tests; the addition of chelating agents or serial dilution methods seriously alter the chemical and physical properties of the effluent. A toxicity test, based on the survival time of Ceriodaphnia dubia (Crustacea, Cladocera) neonates exposed to the unchanged effluent, was developed and field validated, on an AMD contaminated site.     

Influence of zeolite structure and chemistry on the electrical response and crystallization phase of poly(vinylidene fluoride)

Zeolites with framework types LTL, LTA, FAU, and MFI were synthesized and used as fillers to prepare PVDF/zeolite composites. The obtained composites showed structural and electrical dependence on the pore system and chemical content of the inorganic host. The larger polymer-zeolite electrostatic interactions of the Y and A zeolites lead the polymer to crystallize in the electroactive γ-phase, which in the case of the L zeolite is prevented due to the reduced interaction area. The solvent and water encapsulation ability of the zeolite as well as improve of the dielectric response of the composite is directly related to the Si/Al ratio, leading zeolites with lower Si/Al ratios to larger dielectric responses and encapsulation efficiencies in the composites. These effects show also some dependency on the dimensionality of the pore system; the zeolite L-containing 1D channels showing superior dielectric performance than the 3D pore system of zeolite Y.     

A hybrid model for a multiproduct pipeline planning and scheduling problem

Brazilian petrobras is one of the world largest oil companies. Recurrently, it faces a very difficult planning and scheduling problem: how to operate a large pipeline network in order to adequately transport oil derivatives and biofuels from refineries to local markets. In spite of being more economical and environmentally safer, the use of a complex pipeline network poses serious operational difficulties related to resource allocation and temporal constraints. The current approaches known from the literature only consider a few types of constraints and restricted topologies, hence they are far from being applicable to real instances from petrobras. We propose a hybrid framework based on a two-phase problem decomposition strategy. A novel Constraint Programming (CP) model plays a key role in modelling operational constraints that are usually overlooked in literature, but that are essential in order to guarantee viable solutions. The full strategy was implemented and produced very adequate results when tested over large real instances.     

Voltammetric investigations on the transition between dissolution, passivation and deposition characteristics of Ni, Cu and their alloys in fluorine based ionic liquid

Multisweep cyclic voltammetric (CV) responses of nickel, copper, Monel and nickel–copper alloy had been extensively studied and compared in a variety of non-aqueous solvents such as acetonitrile (AN), propylene carbonate (PC) and sulfolane containing triethylamine trishydrogen fluoride (TEA·3HF) ionic liquid. The quantity of dissolution as well as surface morphological transformation on the electrode surfaces as a result of anodic polarization were investigated using atomic absorption spectroscopy (AAS) and scanning electron microscopy (SEM) respectively. The nature of crystallites formed on the polarized electrode was characterized using X-ray diffraction (XRD). The voltammetric study clearly indicates that Ni, Monel and Ni–Cu alloy are passive and stable in neat TEA·3HF medium in the recorded potential region of CV. Surface morphology of Ni after polarization, reveals the generation of pits, whereas the evolution of small crystallites of CuF₂ are noted on the polarized alloy material, as evidenced by SEM pictures. Copper electrode shows reversible voltammetric characteristics with high charge recovery ratio (q_c/q_a) suggesting that in this medium, Cu can certainly serve as reference electrode. Addition of water in TEA·3HF medium increases the solubility and stability of these metal fluoride film. In solvents such as PC, AN and sulfolane containing TEA·3HF, Ni and their alloys exhibit remarkable passivity and the charge recovery ratio decreases to some extent for Cu. In TEA·3HF/AN medium, the dissolution of Cu is very high. The present investigation suggests that the relative stability of all the four electrodes in neat TEA·3HF and solvents containing 0.1 M TEA·3HF decreases in the order: Ni > Monel > Ni–Cu alloy > Cu and relative solubility of metal fluoride films in the three solvents increases in the order: PC < sulfolane < AN.